MFT/Woodpecker Superfence/Xacta router lift

[protohyp]

Decided I don't do enough routing right now to justify the CMS table so decided to ghetto one together.  Cut a phenolic top and dropped the Xacta lift in there.  I know it's old. Maybe I'll buy a new plate or reanodize.  Found an extra miter gauge and the woodpeckers fence attaches perfectly to it.  Maybe I can put a micro adjust system on there.  Haven't squared it yet but really excited to get it up and running

Sent from my iPhone using Tapatalk

 

[HarveyWildes]

Interested to know how it works.

 

[protohyp]

Interested to know how it works.

I'll update in the morning.  I haven't squared it yet so will let you guys know when I run the first board

Sent from my iPhone using Tapatalk

 

[protohyp]

Just squared it and ran a bunch of boards and it works great!  No vibration or chatter. 

I needed to level the bottom plate to properly match the level of the miter gauges so I lifted it a 1/4" and it helped square the fence with minimal adjustments to the built in fence levelers

So far so good and done for under 400.00 although I was able to get the extra miter gauge for a good deal

Sent from my iPhone using Tapatalk