Mounting a Kapex

[Pmooradian]

I'm making a custom stand for my Kapex. Does anyone know the exact distance (center to center) between the rubber feet? Front to back and side to side. I think I am just going to set the saw's feet into holes drilled with a forstner bit, similar to the MFT table.  Also, can someone confirm diameter of the feet? I think I saw 20mm somewhere.

 

[Shane Holland]

Welcome to the forum. The feet are made to fit into the 20mm holes on the MFT Kapex.

Here are the dims. If you need centers for the feet, I (or someone) can probably get those for you.

 

[Shane Holland]

Measuring the holes on my MFT Kapex, center are as follows, best I can tell using my tape.

575mm x 385mm @ 20mm diameter

With the feet being exactly 18.5mm.