Multi sawblades Kapex

[lerberg1969@gmail.com]

Hello!

Is it possible to put multi sawblades on a Kapex to saw a wider cut, than it would be with a single blade??

If it is possible, maybee I had to use a different blade lock?!

 

[usernumber1]

i just did a blade change it's pretty tight in there with the plastic shroud. there's more than just the bolt restricting the space. maybe two thin kerf if there's such a thing.

also, the nut also kind of lines up flush if that makes sense. i think it would be a pretty big challenge

 

[ear3]

[member=63921]lerberg1969@gmail.com[/member] Sounds iffy, even if mechanically feasible (which it may not be for the reasons outlined above).
Presumably you're trying to cut a groove or dado?  With the trenching stop of the Kapex, which allows cutting at a specific depth short of the full workpiece, why not just do it in multiple cuts?  Cleanup can be done with a narrow chisel or router plane (if you have that available)?

Hello!

Is it possible to put multi sawblades on a Kapex to saw a wider cut, than it would be with a single blade??

If it is possible, maybee I had to use a different blade lock?!

 

[kevinculle]

I've never tried it but it's clear to me from doing routine blade changes that the Kapex is not designed for or suited to blades with a kerf much wider than 1/8" (3.2mm) or so.