NEW festool MFT fence mounts

[backhoebb]

Hey all.

As many users of the MFT, it's a love hate relationship. Festool's fence mount, while very neat, is over engineered, and under
performs in my opinion. I wanted a ridged and reliable mounting system, that leaves maximum space left on the MFT surface for cross cutting, and assembly, Here is my solution. The mounting plates are designed to maximize table depth, increase rigidity, and work with a wide range of aluminum fence extrusions.They also Allow the MFT to be used very close to a wall, without limiting usable crosscut capacity.

[attachimg=1]

[attachimg=3]

[attachimg=2]

 

[gsdvorak]

Nice solution!  Allows the opportunity to pitch the protractor that I have never used, but keep the fence which I do like.  Are you looking to mass produce?

 

[backhoebb]

If there enough interest I will make a run of them, to sell. to be honest, this solution came about as a result of my total frustration with the current system. These were just an idea, but they work SO WELL!