Part Missing From MFT/3 Bevel Clamp - Help Me Identify It

[Grasshopper]

I have been noticing that my MFT/3 fence easily slips out of square and I think I have tracked down the culprit.  I purchased my MFT used at a garage sale of all places, and I think I am missing a critical part.

I was watching this YouTube video and spotted them tightening a small black plastic screw to the right of the bevel (see the video at 4:08 where they tighten it up )

Sure enough, I don't have that.

I've attached pictures of mine on the right and left side.

If someone out there in FOG land, could take close up pictures of the missing part (either on or off the MFT Bevel clamp is fine), that would help.  Better yet, if you know of the part number or specs of the bolt, I'd really appreciate it.

Here is my setup:

Right Side
[attachimg=1]

Left Side
[attachimg=2]

 

[AlexThePalex]

Looks like you're missing parts 24, 33, 34 and 36. With the numbers in the table below you can order them from a dealer or directly from Festool.

[attachimg=1]

[attachimg=2]

 

[Grasshopper]

Thanks for taking the time to answer my question Alex. That helps a bunch.

Looks like you're missing parts 24, 33, 34 and 36. With the numbers in the table below you can order them from a dealer or directly from Festool.

[attachimg=1]

[attachimg=2]

 

[Grasshopper]

Replacement parts ordered.  Thanks for help with part numbers etc.

THANK YOU FESTOOL FOR ROCKING CUSTOMER SERVICE!!!