Hello all,
Do you guys have any idea on how to build a planer sled for jointing on the planner the Festool way?
I was thinking if it's a good idea to use an MDF sheet cut 13" wide (because my Ridgid planer is 13.5" wide) with holes in it, a lot like the MFT table top. Then using the Festool clamping elements to hold the piece in place, of course with the wedges under the wood pieces to plane out the defects.
Your brainstorming ideas will be much appreciated. Thanks!
Do you guys have any idea on how to build a planer sled for jointing on the planner the Festool way?
I was thinking if it's a good idea to use an MDF sheet cut 13" wide (because my Ridgid planer is 13.5" wide) with holes in it, a lot like the MFT table top. Then using the Festool clamping elements to hold the piece in place, of course with the wedges under the wood pieces to plane out the defects.
Your brainstorming ideas will be much appreciated. Thanks!
