POLL: What level of interest is there in the Vac-Sys in the US/Canada?

[jonny round boy]

Shane while we're at it, as I was edge banding yesterday, I was thinking it sure would be nice to have the Cunturo to do this. I have some inside radiuses to do today, I may be thinking other things I can't post here.

I don't recall seeing the Conturo in your time frame post. I need the cordless SDS hammer drill also.

Tom

I'd guess that the future release of the Conturo is the impetus behind the renewed efforts to get the vac-sys approved, since Festool see it as part of the Conturo system.

 

[tiralie]

Shane while we're at it, as I was edge banding yesterday, I was thinking it sure would be nice to have the Cunturo to do this. I have some inside radiuses to do today, I may be thinking other things I can't post here.

I don't recall seeing the Conturo in your time frame post. I need the cordless SDS hammer drill also.

Tom

I'd guess that the future release of the Conturo is the impetus behind the renewed efforts to get the vac-sys approved, since Festool see it as part of the Conturo system.

In that case giddy up. I change my vote to "very interested", bring them both over here soon. Seriously I already have a vacuum pump so I would just get the clamps.
Tim

 

[Administrator_JSVN]

Shane while we're at it, as I was edge banding yesterday, I was thinking it sure would be nice to have the Cunturo to do this. I have some inside radiuses to do today, I may be thinking other things I can't post here.

I don't recall seeing the Conturo in your time frame post. I need the cordless SDS hammer drill also.

Tom, there's no current ETA for the Conturo but the expectation is that we will see it at some in the future but not this year is my expectation. No info on any of the other drills currently either.