Mark Johnson
Member
- Joined
- Oct 27, 2016
- Messages
- 42
Hi,
I purchased the above as well as an Incra LS Positioner Super System 25". I was trying to set it today and I ran into a problem. The two bench dogs that attach to the Plate to the MFT/3 won't slide into the MFT holes when tightened prior to insertion, but do fit when they are slightly loose.
I assume this is correct and I just need to tighten the dogs to the Plate whilst it is in the MFT/3. I can then lock it in place with the the supplied locking knobs and remove and install at will.
However, I feel a little stupid as I can't figure out the best way to tighten the dogs whilst in the table. I don't want to do any damage so I thought I would ask the question and feel very embarrassed when the simple and obvious answer comes back [wink]
Thanks, Mark
I purchased the above as well as an Incra LS Positioner Super System 25". I was trying to set it today and I ran into a problem. The two bench dogs that attach to the Plate to the MFT/3 won't slide into the MFT holes when tightened prior to insertion, but do fit when they are slightly loose.
I assume this is correct and I just need to tighten the dogs to the Plate whilst it is in the MFT/3. I can then lock it in place with the the supplied locking knobs and remove and install at will.
However, I feel a little stupid as I can't figure out the best way to tighten the dogs whilst in the table. I don't want to do any damage so I thought I would ask the question and feel very embarrassed when the simple and obvious answer comes back [wink]
Thanks, Mark