Request for a measurement on UG stand

[fignewton]

Howdy all!  I'm considering getting a UG stand, but the question becomes where to put it in stored position in the shop.  I have a countertop with an opening between base cabinets that I think it would roll into, with the saw underneath and the handle butting up to the countertop.  I need to know the height from the floor to the end of the locking handle on the saw when the saw is folded on the stand.  If it won't fit, then I have to look for plan "B".  Thanks in advance
Fig

 

[Ivan T]

The Kapex UG Stand is 35 3/4 inches tall. There is a UG Stand listed in the Classified Section you may want to look at.

 

[Ivan T]

Oops, the locking handle is 2 1/4 inch below the UG handle. So 33 1/2 is what I measured.

 

[fignewton]

Thanks a bunch.  I have about 35 1/2 under my countertop, so it should slide under there.

 

[ScoFF]

There are $50 similar "dual height tool stands".