Rotex 150 diamond pad

[Pedro]

Greetings to all.  I would like to remove glazing from shelves that are used in a ceramic kiln.  The glaze drips are cooked at high temperature, and are firmly adhered to the shelf.  The drips tend to shatter sharply when removed by hammer-chisel.  Is there a heavy duty diamond pad for the rotex 150 that might smoothly grind off these drips?

Good health, Peter

 

[Cheese]

I'd use a small right angle grinder with a silicon oxide wheel or a diamond cup wheel.

There really isn't anything available for a Rotex. The best Festool offers is Saphir paper but that's aluminum oxide based so that is probably too soft for the ceramic.

 

[guybo]

Hi welcome to the forum festool use to make this abrasive diamate for hard coatings #496512 for the rotex 150. guy