I have the MFT Basis and I'm looking for some simple ways to do repetitive cutting with little or no measurements. I have the TS-PA, The Parallel Guide - 491469 and two pairs of Parf dogs (Quas equivalents). I like the guide rail idea of the full version MFT but I don't fancy the idea of always having the guide rail attached and always pointing to the ceiling.
My question: Is it possible to order 2 sets of the non-pivoting support brackets (EKAT NO 497022) and install each one of them in a mirrored fashion on each side of the table?
This way whenever I need to cut something quickly I can just position my guide rail on top of the brackets utilizing the small tooth thingy (sorry English isn't my mother tongue
) to have a straight cross cut and when I'm done I can remove the guide rail and put it away.
Thanks!
My question: Is it possible to order 2 sets of the non-pivoting support brackets (EKAT NO 497022) and install each one of them in a mirrored fashion on each side of the table?
This way whenever I need to cut something quickly I can just position my guide rail on top of the brackets utilizing the small tooth thingy (sorry English isn't my mother tongue
) to have a straight cross cut and when I'm done I can remove the guide rail and put it away.Thanks!
