wkearney99
Member
- Joined
- Jun 6, 2014
- Messages
- 68
I'd like to have a movable support table when using my MFT3. For various reasons, most of them probably bad ideas. But everyone's work style varies/improves over time, so don't beat me up on the idea. I've already got another work cart and that isn't MFT height either.
Anyway, I bought a SYS-MFT (500076) and was hoping to use it stacked on top of other systainers and a sys-cart (mine being an older 492388). To my dismay I discovered the top of the SYS-MFT ends up being either a couple of inches too short or too tall. I rearranged my various systainers (including an older Sortainer 9) and couldn't arrive at a matching height to the MFT3.
Is there some combination of systainers that will do this? Get the top of the SYS-MFT to nearly the same height as the MFT?
And is there any height difference between the older and newer syscart bases?
Anyway, I bought a SYS-MFT (500076) and was hoping to use it stacked on top of other systainers and a sys-cart (mine being an older 492388). To my dismay I discovered the top of the SYS-MFT ends up being either a couple of inches too short or too tall. I rearranged my various systainers (including an older Sortainer 9) and couldn't arrive at a matching height to the MFT3.
Is there some combination of systainers that will do this? Get the top of the SYS-MFT to nearly the same height as the MFT?
And is there any height difference between the older and newer syscart bases?