Techflex Snagless Festool Vacuum Hose

BillyG

Member
Joined
Mar 11, 2015
Messages
15
I used some Techflex braided sleeving to surround a Festool vacuum hose and power cord, and make it relatively snagless.  See www.techflex.com

IMAG3142_zpsiuitvc9r.jpg


IMAG3140_zps4z5okubw.jpg


IMAG3147_zpsqghz5xq9.jpg


IMAG3149_zpsp1atjseb.jpg


This is the braided sleeve I used: https://www.wirecare.com/product.asp?pn=WC04971303

There are lots more details here:  http://forums.delphiforums.com/breaktime_3/messages/?msg=124.1

Billy
 
There is a very easy way to put the hose and cable into the sheath that is to put the plugit cable unto the tool end of the hose, it is a good fit and there is no need for sticky tape
[attachthumb=1]

FWIW the cable tie holds a hook (out of shot) and is not needed for anything else.
 

Attachments

  • image.jpg
    image.jpg
    634.8 KB · Views: 972
That looks good.  Thanks for the tip.

How do you pull the cable through the sheath?

Billy
 
BillyG said:
That looks good.  Thanks for the tip.

How do you pull the cable through the sheath?

Billy

Well it's been about 5 years now but AFAIR by pushing the sheath over the hose with the plugit fitted as I showed in the picture above. With the 35mm hose I put the plugit inside the tool end of the hose then did the same (hose and cable together).

The plugit in the end of the hose is an easy way to hang the hose to my sliding rails.
[attachthumb=1]
 

Attachments

  • image.jpg
    image.jpg
    2 MB · Views: 1,176
Back
Top