The MFT can indeed be used as an out feed table for the SawStop Jobsite Pro.

[bwehman]

Kind of a random post but it was info I couldn't find a definitive answer for when doing research on this. Hopefully it helps some future searcher.

 

[Ultimate Tools Marketing]

As the saying goes, a picture is worth a thousand words. Thanks for sharing!

 

[MacBoy]

I suggested for the neighbor to use his Kreg MFT table as the outfeed for his Sawstop JSS.

I’ll send him this post as encouragement to give it a try.

 

[Michael Kellough]

I suggested for the neighbor to use his Kreg MFT table as the outfeed for his Sawstop JSS.

I’ll send him this post as encouragement to give it a try.

Is the Kreg table the same height as the MFT/3?

 

[MacBoy]

Is the Kreg table the same height as the MFT/3?

The Kreg table is 33.52" to 36.18" in adjustable height. Each leg is individually adjustable to those heights.

That’s essentially 851mm to 918mm of adjustable height for the Kreg table.

In comparison, the MFT/3 table is 900mm or 35” in height.

 

[Michael Kellough]

The Kreg table is 33.52" to 36.18" in adjustable height. Each leg is individually adjustable to those heights.

That’s essentially 851mm to 918mm of adjustable height for the Kreg table.

In comparison, the MFT/3 table is 900mm or 35” in height.

Thanks for the detailed info. The Kreg table is more versatile than I knew.