The new MFT lever clamps

[Crazyraceguy]

I don't know if this was the intent all along and I just missed it? or if this is the typical "not well explained" thing that seems to happen sometimes.
The thing that I discovered with these new clamps is that they stay in place, making them the "one handed" solution that many have been looking for.
I had several pieces that I was needing to cut Dominos into and this made it very easy. I did it yesterday with some pocket screws too. The clamp stays in place as you slide the parts under, apply pressure, make the cut (drive the screw) etc, then release it.

 

[FestitaMakool]

Just had the set in my door. Hadn’t thought it this way.
(Need “loosening” the holes as well [big grin])

But yes, that’s a very nice feature, if it is a feature? Nonetheless, thanks for pointing it out - I’ll be very very sure to test this feature  [smile] - That’s the great thing about the FOG too - sharing tips, trick and hidden “features”  [big grin]

 

[krudawg]

I don't know if this was the intent all along and I just missed it? or if this is the typical "not well explained" thing that seems to happen sometimes.
The thing that I discovered with these new clamps is that they stay in place, making them the "one handed" solution that many have been looking for.
I had several pieces that I was needing to cut Dominos into and this made it very easy. I did it yesterday with some pocket screws too. The clamp stays in place as you slide the parts under, apply pressure, make the cut (drive the screw) etc, then release it.

Those clamps are available from banggood.  About $15