TS 55 Baseplate

[webfarmer]

After experiencing the horror of knocking my plunge saw off of the table and watching it bounce like a basketball, a new base plate has arrived to remedy my "rocking plunge saw."

Installing it is no problem. 

But is there a good technique for calibrating the blade location so that I do not have to replace all of the strips on my numerous guide rails?

Brett

 

[semenza]

Hi,

    You can try Rick Christopherson's enhanced TS55 Manual here.  Or once you have set you might get lucky and it will be a little closer and just re-trim the strips. Or you can move the strips over. Do a search for    strip  move  and you will get several threads that tell how to do this.

Seth

 

[webfarmer]

Awesome.  Thank you semenza!