Vecturo blades?

[ahelwig]

Im looking into buying the Vecturo.  I was wondering it will accept other blades.  I assume that the festool work the best and plan to stock up on them.  However you know the drill.  I see myself getting low and tell myself to order more, but forget.  Then sure enough Im down to my last blade and in the middle of a job.  Can I shoot to my local Home Depot and pick up a pack of portercable or dremel blades and throw them in to get me through?

 

[erock]

Fein Super Cut blades work with the Vecturo.    The Festool blades are the same as the Super Cut.

Eric

 

[jbasen]

As erock said you have to use the Fein Supercut blades or blades from other manufacturers that are compatible with the Supercut.  Unfortunately, I have never seen any of the big box retailers carry any blades that are compatible with the Supercut; they only carry Multimaster compatible blades and those are different.

If you are looking for lower priced blades than the ones sold by Festool and Fein, you will have to search online for them.

 

[greg mann]

Imperial Blades has a Pretty good selection if youncan find a dealer thatnwill carry the Supercut versions. A little research on dealers or a call to the company might bear fruit.

 

[linnlp12]

You can buy an adapter and use multimaster blades.

 

[Kev]

Just reviving an old Vecturo blade thread ... has anyone tried these? http://multifitblades.ca/festool-vecturo-multi-tool-blades.html/

They ship internationally and they also have a Multimaster adaptor.

 

[rst]

I have the Supercut and bought the Vecturo plunge accessory to use with it.  The Fein adaptor for using the Multimaster blades will not work with the plunge attachment...it places the blades too far away from the magnetic suface.  I buy most of my blades from Ebay- Atzame store, he carries the most useful ones.