want to make a vertical router sled

R

Redcabin

Member
Joined
Aug 14, 2022
Messages
6
[img/Users/stevescott/Downloads/IMG_2301.HEIC][/img/Users/stevescott/Downloads/IMG_2302.HEICg]

I'm trying to make a router sled for larger objects like a 35" tall log and an upside down stump that do not show in the preview. A farrier wants to mount an anvil at a certain height. That's what the large piece is for. The other one seems interesting to flattening from the bottom. Obviously I can't set these on a table and flatten away like a normal person. Cam at Blacktail Studio has a frame setup of some sort but I haven't seen where he describes it. I have a few pieces of 4545 extrusion but that's as far as I've gone. Thx
 
From the post, I thought he wanted a sled that went from the ground up, or from the top down. 

If I had a smooth, level floor, I’d just mount the router on casters and roll it around.

I’m still not sure what the OP was looking for though.
 
You must log in or register to reply here.
Back
Top