John Beauchamp
Member
- Joined
- Dec 15, 2014
- Messages
- 109
Has anyone tried to put wheels on an MFT without raising the height more than about 1/4". My shop was set up to work fine before I got the MFT/3. I mostly used it for a pattern to lay over and drill holes in my run out table. Now it's in the way and without wheels it's hard to move. I do use it for certain cuts that are easier than on the table saw but mostly its just another flat surface that gets filled with junk till I need it. I don't want to take the legs off as it still can be used on a job site. I'm thinking U shape so I can still keep the CT under it. Any ideas?