Tomfoolery
Member
- Joined
- Apr 20, 2012
- Messages
- 11
What is the best way to rip boards that end up being not wide enought to span the distance between the blade on the saw and the undermount clamp on the guiderails?
What i have been doing is finding a scrap that is the same thickness and placing it next to the board I am ripping to try and keep the guide level for the cut.
Any other suggestions or better ideas?
Thank you!
What i have been doing is finding a scrap that is the same thickness and placing it next to the board I am ripping to try and keep the guide level for the cut.
Any other suggestions or better ideas?
Thank you!