3m PPS System for a Fuji Gxpc spray gun

[wptski]

I see those mods were done a little over a year ago. Did they work well? What parts did you use and where did you purchase them? Please elaborate. Thanks, Mike

All parts was made on a 10" metal lathe I own, all worked better than the OEM setup, being to rotate the PPS allows better weight distribution to your wrist.  Make the new hex fitting with a Push To Release connector removing the barb(which I had to cut off) makes it easier also.

The fluid coupler was made out of stainless steel and the air fitting out of aluminum with an added "O" ring to seal any possible leaks.

 

[Mike27520]

sent you a message.

 

[wptski]

sent you a message.

Answered it.

 

[tiralie]

Yes, but nobody believed me.

Tom

I believe everything you say [wink]