Just wondering if anyone has experienced this problem and if there is a solution.
I am using TS55 on CMS table and when using mitre gauge with sliding table attatchment, cuts are perfect 90 degree and square.
When I then adjust the angle-of the TS55 to 45 degrees for a mitre cut, the cuts are no longer 90 degrees. I am baffled at how this can be so.
Is there an adjustment in the saw to fix this inconsistency when performing cuts at different angles.
I am using TS55 on CMS table and when using mitre gauge with sliding table attatchment, cuts are perfect 90 degree and square.
When I then adjust the angle-of the TS55 to 45 degrees for a mitre cut, the cuts are no longer 90 degrees. I am baffled at how this can be so.
Is there an adjustment in the saw to fix this inconsistency when performing cuts at different angles.