Anyone thought about getting the Carvex + accessory kit all in one systainer?

[amt]

I occurred to me it might be nice to fit the Carvex and the contents of the accessory kit all in one systainer.  I don't have a sys3 to check, but I was hoping that might do the trick.  I would have the Carvex lay upright (and not on the side like it comes), and then create some dividers to hold various bases.  I guess I need to take some measurements.  Anyone know what the -inside- height is for a sys3?

 

[elfick]

If you don't mind using (or converting from) metric, the Tanos sustainer catalog gives inside and outside dimensions for all the systainers. I'm not sure if the inside dimensions take into account the ribbing, but it should be close enough for what you are figuring out.

http://www.tanos.de/admintool4/upload/csdownload3.aspx?id=552&org=000&key=73f5c68ad4ed0caeec9c5356bacfbe9b21eb3c572a95bdc6be1fae116a0ea24d&dlan=En

 

[ScotF]

I think it would be a pain to have everything jumbled together personally.  I like the accessory Systainer with everything organized.  With that said, if I were buying over again I would probably just get the circle cutter attachment with the basic saw and skip the other bases -- it has worked for my application so far and that would fit in one Systainer without an issue.

Scot

 

[Jak147]

I seem to remember seeing a picture here somewhere, where a member had used a sys2 and had the bases on a bottom and the saw and spare blades on a top tray, looked like something I might do if I had a carvex [sigh]

 

[semenza]

Sys - III is about 7" inside height +/-  depending on the exact location. If not using an attic lid there is a little height inside the lid too.

The five drawer Sortainer might do the trick too.

Seth

 

[jimmylittle]

I did it, and it works well.  The Carvex and the accessories all fit in the Sys 2 the Accessory kit comes in.  I just built some plywood dividers in the bottom, then took the Carvex tray out of the Sys1 and placed it on top. 

See the thread:

Carvex and Accessories in a Sys 2

 

[GreenGA]

I was thinking about this this morning and wondered if the OP wanted to keep/use the inserts for the Carvex -and- the accessories.  If so, then how about using a Sysmaxi?  It's two standard sized Systainers, side by side. Since the 'tainer would be carried from the side, rather than upright, perhaps a thick piece of foam attached/glued to the lid would keep everything in place during transport.

JMTC...