narrowboatboy
Member
- Joined
- Dec 2, 2011
- Messages
- 60
hi all had a little problem with not enough worktop to set up a run of the meal worktop jig, and after my mdf jig got wet and the pin wouldn't align properly so i splashed out on a APS900.
pic 1, pic 2, as you can see from the worktop isn't long enough to reach the wall, so how to set up the jig
pic 3, measure the distance to wall
pic 4, slap on your APS 900
pic 5, APS start point.
pic 6, APS after adding on measurement to wall
pic 7, cut joint
pic 8, job done, sorry about mess
the APS makes this type of offset mitre really easy
pic 1, pic 2, as you can see from the worktop isn't long enough to reach the wall, so how to set up the jig
pic 3, measure the distance to wall
pic 4, slap on your APS 900
pic 5, APS start point.
pic 6, APS after adding on measurement to wall
pic 7, cut joint
pic 8, job done, sorry about mess
the APS makes this type of offset mitre really easy
