Attention Festool: MFK 700 suggestion

[polarsea1]

Mounting or dismounting the sensor bearing requires removing two small screws which I am likely to lose forthwith. Please consider making the plate with keyholes in the slots so that the screws can be loosened rather than removed. 

It wouldn't hurt my feelings if you included a nice green handled allen wrench in the kit - make it big so I can find it.

 

[Brice Burrell]

Mounting or dismounting the sensor bearing requires removing two small screws which I am likely to lose forthwith. Please consider making the plate with keyholes in the slots so that the screws can be loosened rather than removed. 

It wouldn't hurt my feelings if you included a nice green handled allen wrench in the kit - make it big so I can find it.

While the in Henderson one of the Festool trainers mentioned Festool was looking into a redesign for the sensor bearing so it would be tool less install/removal.

 

[polarsea1]

Good to hear, Thanks Brice.

Bill