Carved circle cutting accessory

[adkinsb48]

Lost the pen that goes in the pivot hole. How May I get replacement or what can be used as replacement.  It needs a good fit - any slop throws the circle off. Thank you for the help. 

 

[Chip S.]

Sounds like you're looking for part #479479 (#16 in the parts diagram).

View attachment 1

 

[Coen]

Yes, that's the number. Any Festool dealer can order that for you.

 

[PaulMarcel]

[member=62369]adkinsb48[/member] meant to reply back with a number when you first posted... mea culpa

The pin is 3.94mm diameter so just use a 4mm brad-point drill bit until a replacement comes in. If you only have bits in Freedom Units, 5/32" will be snug (wax it?) but might work.

 

[adkinsb48]

Thank you so much.  You guys are the best. 

 

[Coen]

[member=62369]adkinsb48[/member] meant to reply back with a number when you first posted... mea culpa

The pin is 3.94mm diameter so just use a 4mm brad-point drill bit until a replacement comes in. If you only have bits in Freedom Units, 5/32" will be snug (wax it?) but might work.

Haha, the units of the empire you guys got away from by fighting them... [big grin]