Centrotec bit for Kreg Bit and DowelMax bit

[webpp]

Does Festool sell any Centrotec bit that works with the Kreg Jig and DowelMax?

If so, link and detail would be much appreciated.

 

[rljatl]

Snappy makes a 6" square drive bit.  Atlas also makes Centrotec square drive bits, but they are only 4" long.  Don't know about imperial drill bits.

Scroll down for the 6" Snappy square drive.
Cetrotec Square Drive Bit

 

[webpp]

What about a 3/8" and 1/4" drill bit in Centrotec so that I can use it with the Dowelmax.

 

[Svar]

Festool had a limited run of imperial sizes drill bits in the installer set. Might work for DowelMax, but not for Kregg jig. Not available any more anyway.
Try Snappy, a US company that makes Centrotec compatible bits.

 

[Administrator_JSVN]

No, that is not something that we have available at this time.

 

[rmwarren]

[member=57231]webpp[/member] - you could try modifying standard 1/4" bits as discussed here.

RMW

 

[Cheese]

What about a 3/8" and 1/4" drill bit in Centrotec so that I can use it with the Dowelmax.

This is probably what you're looking for to use in the DowelMax. However, as Svar noted, it was a limited production kit, run about 2 years ago, P/N 201312.

The problem then was, and still is, that Festool never made individual replacement drills available. So if you lost one or damaged one, well that's just too bad...they called it tough love. [sad] 

 

[semenza]

Snappy makes a 1/4" (also available in a set), and 3/8" centrotec bits (not in the set). Shop the net to find them. But no step (?) drill bit for the Kreg.

Seth

 

[skinee]

for a kreg drill bit the following is centrotec compatible,its from axminster here in the U.K. a very reputable company,many on here from the US and elsewhere have ordered from them and found shipping easy and inexpensive I believe,you will also be able to deduct 20% from the price(sales tax)as you are outside the U.K.

  http://www.axminster.co.uk/ujk-technology-pocket-hole-drill-bit-hex-shank-103397

 

[Klemm]

does anyone know of a source for individual 20mm CentroTec bits in the US or elsewhere?
Hans

 

[Cheese]

does anyone know of a source for individual 20mm CentroTec bits in the US or elsewhere?

Brad point bit or Forstner style bit?

 

[rmwarren]

[member=59331]TSO Products[/member]  - Hans, you may want to contact Fisch, they seem to have a lot of Centrotec compatible stuff.

RMW

 

[Klemm]

does anyone know of a source for individual 20mm CentroTec bits in the US or elsewhere?

Brad point bit or Forstner style bit?

same style as sold by FESTOOL in sets -( which I have not seen)

Hans

 

[Cheese]

same style as sold by FESTOOL in sets -( which I have not seen)

That'd be a brad point then.