I have had problems with the magnet coming out of all my centrotec bit holders. Could I get some suggestions on what adhesive/method any of you have used to secure the magnet. I have been using the T15, which is probably to hard on the standard holder. I have been using the 1" bits from Festool and Lee Valley for the ones Festool does not offer. Thank You
Centrotec Bit Holder
- Thread starter Jim Green
- Start date
Sparktrician
Member
I'd suggest a dab of two-part epoxy. Haven't needed to do it myself, but that's what I'd do if I did.
Similar threads
