CS 70 LA Stopper Fence - Tightening

[Jimmy FineCut]

The end clamp on my CS 70 LA stopper fence has stopped clamping down tight to the mft profile. I have the festool instructions showing how to use it, but no mention on adjument to the end clamp item number 20.

Can anyone point me in the right direction before I start taking bits apart!

 

[AlexThePalex]

Just take it apart, clean it and put it back together. It's not that complicated.

 

[Jimmy FineCut]

Well yes that might work Alex, but how is the tightness adjusted in the first place?!

 

[dltflt]

I don't have a CS70 but usually there is set screw or grub screw to tighten any of there clamps.

 

[Frank-Jan]

Mine fell out of the rack in the back of my van once, and afterwards I had the same problem.
You have to remove the  torx screw at the back and and reassemble the rod with the little springclip.

 

[Jimmy FineCut]

Mine fell out of the rack in the back of my van once, and afterwards I had the same problem.
You have to remove the  torx screw at the back and and reassemble the rod with the little springclip.

Cheers I will give that a go.