Hello!
First time poster long time lurker as the saying goes.
I bought a used CS 70 that is from 2000 part no. 489841. It's seen some use over the years, but generally in good condition. I had to replace the belts, and one belt pully to get it running smoothly.
I noticed the riving knife sits 2 mm to the right of the blade. I thought maybe the riving knife and its assemble was bent, but I bought a replacement part the problem is still there.
To confuse things even more the arbor doesn't really match the drawing from EKAT. I bought a new blade flange and it came with spring washers and a drawing on where to put them. They do not fit at all onto the arbor and when installed like in the drawing you can't thread the bolt.
Anyone have experience with this on their CS 70? Or maybe you can take a picture of your arbor / blade mount so I can see an example.
Thanks for the input [smile]
First time poster long time lurker as the saying goes.
I bought a used CS 70 that is from 2000 part no. 489841. It's seen some use over the years, but generally in good condition. I had to replace the belts, and one belt pully to get it running smoothly.
I noticed the riving knife sits 2 mm to the right of the blade. I thought maybe the riving knife and its assemble was bent, but I bought a replacement part the problem is still there.
To confuse things even more the arbor doesn't really match the drawing from EKAT. I bought a new blade flange and it came with spring washers and a drawing on where to put them. They do not fit at all onto the arbor and when installed like in the drawing you can't thread the bolt.
Anyone have experience with this on their CS 70? Or maybe you can take a picture of your arbor / blade mount so I can see an example.
Thanks for the input [smile]
