Lucky Dave
Member
- Joined
- Oct 3, 2007
- Messages
- 102
I use a TS 55 on a dual MFT 3 with guide rail.
Cut a 38" x 20" board. Then, just double checking, took at close look at squareness.
Short story, much to my suprise I found the 38" side not straight! Bulged out about 1/16 then narrowed down to about 1/32 off straight. Checked straightness with MFS 700.
Using Festool 48t blade, speed 6, cutting baltic birch at moderate feed rate.
Inspected blade. Looks good with some resin or whatever buildup. Cleaned with blade cleaner and knocked/brushed off loose sawdust from saw.
What else should I consider.
Thanks
Dave
Cut a 38" x 20" board. Then, just double checking, took at close look at squareness.
Short story, much to my suprise I found the 38" side not straight! Bulged out about 1/16 then narrowed down to about 1/32 off straight. Checked straightness with MFS 700.
Using Festool 48t blade, speed 6, cutting baltic birch at moderate feed rate.
Inspected blade. Looks good with some resin or whatever buildup. Cleaned with blade cleaner and knocked/brushed off loose sawdust from saw.
What else should I consider.
Thanks
Dave