So 7 days after Toolnut shipped my CXS it finally arrived today (5 days behind the centrotec installer kit - thanks USPS!). I charged it up fully this evening and wanted to give it a spin. It's bogging down and cutting out with the brand new centrotec 1/2inch brad point on some 2x4 stud I had lying around. Only gets about half an inch or so before it locks up and I have to back it out [eek]. This was on drill mode on #2 (hi-speed). After watching videos of guys using 1in spade bits with this drill, I'm a little confused!
So I did primarily get it for small work and have a set of DeWalt 18V's for bigger stuff but I was expecting a little more.. Any advice is much appreciated.
So I did primarily get it for small work and have a set of DeWalt 18V's for bigger stuff but I was expecting a little more.. Any advice is much appreciated.