Favorite Drawer Pull Jig

[Deadskins]

I have not posted in a bit.
Moved, unpacked and close to finishing my wife's monster kitchen.
I have installed 25 cabinets and and now must install the drawer and door pulls.  Eight years ago I used the rockler jig with some success.  But this time I have a lot more to install 30 drawer and 23 door pulls.

Any suggestions drawer and door pull jigs?

Thanks in Advance

Ranny

 

[Sparky]

"The Euro jig"is really good and is able to center on a 24" drawer and usually anything at 27" or bigger gets two handles on a drawer front so works well for bigger drawers with 2 handles as well. Easily works for doors. I believe it's around $45.

 

[polarsea1]

True Position jigs are really nice.

 

[Deadskins]

"The Euro jig"is really good and is able to center on a 24" drawer and usually anything at 27" or bigger gets two handles on a drawer front so works well for bigger drawers with 2 handles as well. Easily works for doors. I believe it's around $45.

I have a total of 9 36" drawers.  Are saying I should use 2 pulls on them?  My wife picked out 9" pulls for those.  I would think one would be enough.

 

[illumicon1]

True Position jigs are really nice.

+1 for the True Position jig.

 

[Phred]

+1 for True Position

 

[Deadskins]

Thanks for the responses.  I ended up getting the True Position and installed 45 door and drawer pulls this weekend.  It was truly painless and I did not end up making any errors.  I even used my level to verify that four wall cabinet pulls were the same level.