Felder K700 or K500 tablesaw question

[9Fingers]

Hi, I have a Felder K500 saw and am looking for some help to adjust the travel of the sliding table. It is about 7-10 thousandths off and the work pieces are contacting the rear of the blade as they are pushed by. I bought this saw used and suspect the table was moved slightly in transit. I have the user manual from Felder but it doesen't cover that adjustment
Any help is appreciated, thanks.

 

[Sparktrician]

You can always contact Felder Tech Support.  [smile]

 

[egmiii]

Sign up for the Yahoo Felder Owner Group and repost. It's an archaic format, but you will get a solid answer likely within the hour. I'd add a few more details about the machine and the specifics about how you are making the cut.

 

[lwoirhaye]

You might want to check to see if the blade is heeling first.  That would be an easier adjustment. 

I have a Felder and the blade is heeling a little.  It didn't when I got it but I've moved it around a lot on a pallet jack and I think it may have drifted a little.  It's heeling on the rip side though so it's a less pressing concern to me, which is why I haven't got around to adjusting it.