Festool CMS WA Angle Stop - Can It Be Used with MFT/3

[tyke]

I have a basic MFT/3 table and wanted to add the angle stop but Festool can't supply me with a part number to order it separately. So I wanted to know if the WA Angle Stop (488451) from the CMS  sytem could be used instead.

Thanks
Andy

 

[jmac80]

Don't see why not.
Just the fence is not as long and the in/out slider is longer than  the mft one.

 

[pingvinlakrits]

It fits and I use my CMS/CS50/CS70 WA on an MFT/3.  The base assembly is the same. However the sliding support wing is a little shorter. It can be ordered though, I ordered the correct length for mine as the WA I had (bought used) had been sawed into.  [crying]

I am surprised they can't get you the EKAT number for it. 

 

[peter halle]

Yes it fits.

Peter

 

[tjbnwi]

It works.

Tom

 

[peter halle]

There isn't an ekat for the whole assembly as it comes on the MFT/3 - just separate parts at a higher price than the part for the CMS sliding table.  The longer rear rail (profile) is part number 475217.

Peter

 

[tyke]

Thanks for all the replies. I did contact Festool UK and after referring back to Germany they  were unable to give me an Ekat number for the whole assembly.  They were somewhat surprised that it couldn't be purchased as an option to the basic table.

 

[sancho57]

Put a Want to buy (WTB) in the classifieds here. You might get lucky.

 

[paulc75]

Yup, works just fine