Flattern a blades teeth

[easty]

Is it possible for companys offering blade sharpening to flatten the top of the teeth on a Festool blade. ? like this offeringhttps://www.timbecon.com.au/torquata-flat-top-dado-saw-blades

Rob

 

[Cheese]

Forrest offers what they refer to as their #1 OD tooth style designed specifically for box & finger joints. 
https://www.forrestblades.com/saw-b...square-cut-box-and-finger-joints-40-teeth-en/

 

[easty]

The problem is though I need it for the TKS80 table saw  which is a 254mm blade and  2.40 mm kerf and a 30mm hole.

Rob

 

[Cheese]

Well Rob, if you order the WW10401100 with a 30mm bore Forrest says the dimensions are:

10" OD..........254mm
30mm bore....30mm
3/32" kerf......2.38mm kerf

I'd say that's close enough. [smile]  They also offer this same blade in a 3.2mm kerf version...that's the one I own.

 

[Duckler]

I am sure my sharpening service (where i take stuff) could do that.
Where are you located?

Is it possible for companys offering blade sharpening to flatten the top of the teeth on a Festool blade. ? like this offeringhttps://www.timbecon.com.au/torquata-flat-top-dado-saw-blades

Rob

 

[easty]

I'm located in Sydney Australia Thanks so much for the help

Rob