Flip stops for KA-UG extensions

[broseiden]

Are the flip stops available for purchase independently of the extensions? I tried searching in EKAT, but maybe I'm not using it properly.

Thanks! - MIKE

 

[SMJoinery]

Hi Mike

I'm fairly sure part number is 488560.
Regards
Scott

 

[GarryMartin]

I'm fairly sure part number is 488560.

That's for the older discontinued extension set. AFAIK, the "Stop Flag" on the KA-UG arms is not available as a single part number.

 

[tbellemare]

The MFT Flag Stops work fine. The only difference is the actual flag. You can modify the long side or just use the short side.

Tom

 

[dltflt]

I am using the MFT flag stops

 

[neeleman]

Not sold as one part but only the replacement parts according the EKAT.
From #497207 or 497221 you need parts: 2, 5, 9, 10, 11, 12, 13 and 15.
[attachimg=1]

 

[tjbnwi]

As Tom said you can use either flag stop. When I flip the stops down I leave it up off the surface. Nothing will screw up a setting faster than sawdust between the work piece and the stop. Take a look at the farthest stop in the picture, you will see the long arm is towards the UG support surface.

Tom

 

[broseiden]

Thanks everyone -- ended up buying a total of 5 to use between my MFT and Kapex

Plus the included ones, that is