I really do appreciate the support guys [big grin] but I tend to tread to the cautious side. I decided for neatness of the forum to just post here.
Below you will see the digital image sent to me and then what I honestly feel is a better alternative. In discussions with the company, straight stitches in combination with small curves or italics don't make the stitching software happy. I guess that a carpenter wrote the software [scared].
Anyway, the only difference is that I am proposing is to reduce the number of green "holes" in the "O" to reduce the clutter. I would suggest getting rid of all of the holes except for the center hole but after playing with it I found it to lost the "pop" and it became boring to me. The actual dimensions of the large portion of the image is approximately 3.5 inches wide by 1 3/8 inches tall. The smaller holes are approximately somewhere around 1/8 inch in diameter. These images will also give an indication of the overall quality of the work. I anticipate that the final product will be slightly better than these images.
Feel free to post your thoughts.
__________________________
Image 1 - Original Image
[attachimg=#]
__________________________
Image 2 - Proposed Image
[attachimg=#]
PS. I am going to send an email to all the members who ordered notifying them of this thread and inviting their thoughts.
Peter
Below you will see the digital image sent to me and then what I honestly feel is a better alternative. In discussions with the company, straight stitches in combination with small curves or italics don't make the stitching software happy. I guess that a carpenter wrote the software [scared].
Anyway, the only difference is that I am proposing is to reduce the number of green "holes" in the "O" to reduce the clutter. I would suggest getting rid of all of the holes except for the center hole but after playing with it I found it to lost the "pop" and it became boring to me. The actual dimensions of the large portion of the image is approximately 3.5 inches wide by 1 3/8 inches tall. The smaller holes are approximately somewhere around 1/8 inch in diameter. These images will also give an indication of the overall quality of the work. I anticipate that the final product will be slightly better than these images.
Feel free to post your thoughts.
__________________________
Image 1 - Original Image
[attachimg=#]
__________________________
Image 2 - Proposed Image
[attachimg=#]
PS. I am going to send an email to all the members who ordered notifying them of this thread and inviting their thoughts.
Peter
