Crazyraceguy
Member
- Joined
- Oct 16, 2015
- Messages
- 4,901
This is a profile that I created while messing with Shaper Studio, when it was first introduced. It has been sitting in the cloud ever since, kind of forgotten. I noticed it the other day and have a few minutes to cut out a couple of them. I intended to just cut the "tester" from 1/4" MDF, but I decided I liked it looking so light.
I cut out another one and glued them to a 6" x 9" piece of 1/2" ply. Originally I set it up high on the wall behind the main box and took some pics. Later I found a better place down lower on the low section of the wall, but forgot to take another one.
I like it, so I think I will scale it up some and make bigger ones.
I cut out another one and glued them to a 6" x 9" piece of 1/2" ply. Originally I set it up high on the wall behind the main box and took some pics. Later I found a better place down lower on the low section of the wall, but forgot to take another one.
I like it, so I think I will scale it up some and make bigger ones.
