- Joined
- Jun 24, 2007
- Messages
- 10,359
Hi,
I cut a notch in one of my Deflectors and removed the side projection on the bottom. This allows it to be positioned in either Guide Rail slot. I thought this might help a bit when the hose is dragging from the left. I also plan to use a heat gun or something to heat up the plastic enough so that I can bend the sides out a little. A flare out may also help when the hose is coming from the extreme left or right. Not sure yet how much difference this makes but it is easy to do. I marked out the section to remove with an exacto knife and small saddle square. Went to a utility knife to get a good line / cut part way through. Then finished off with a hack saw. I am sure a band saw would make quick work of this.
srs
I cut a notch in one of my Deflectors and removed the side projection on the bottom. This allows it to be positioned in either Guide Rail slot. I thought this might help a bit when the hose is dragging from the left. I also plan to use a heat gun or something to heat up the plastic enough so that I can bend the sides out a little. A flare out may also help when the hose is coming from the extreme left or right. Not sure yet how much difference this makes but it is easy to do. I marked out the section to remove with an exacto knife and small saddle square. Went to a utility knife to get a good line / cut part way through. Then finished off with a hack saw. I am sure a band saw would make quick work of this.
srs