Have multiple MFT tops, now what?!

[Fest_fool]

Greetings group!

After purchasing my MFT/3 I was dismayed to learn the top had some sag to it right out of the box. Festool sent replacement after replacement but each one was damaged in shipping one way or another. Ultimately a dealer ha d delivered me a flawless one. Now I have a total of 5 ! What would you do with them? I’m currently in the EU and my thought was to try and get the long rails and make a wide table with 2-3 of the tops and arrange support for the midsection somehow.

Anyway, just curious as to how YOU would proceed!

 

[tallgrass]

make a large MFT. Straighten the ones you have and have a great time.

 

[Fest_fool]

Tall grass, would you try and buy the long rails or get more regular rails and use the connectors to extend it?

 

[mrboult]

Are you shop based or do you travel too? I used those 3D printed clips to make small (60x40cm approx) MFT tops for systainers. Very useful on a job. Either just one for a small cutting or clamping surface or a few spread out for bigger cutting surfaces.