Jessem roller stock guides ?

[nclemmons]

As an FYI, I contacted Jessem to ask about the option of these being available for a table saw with the reverse of the angle in the router table.  These would allow for stock movement from left to right.

The current ones support stock movement from right to left.  I have them for my CMS table.

They said they are working on them for the table saw as well.

neil

 

[semenza]

  I used the router table guides today for the first time. They worked very well. I am sure they will not be good for all operations , but what is? I have them on an Incra Wonder Fence. I was making half round trim using a round over bit. Routing the edge of a seven foot long,  wide board then ripping the piece off. Since I was using a round over I had to run the board flip it and  then run the other side, rip and repeat.  Made about 60 feet. The guides made the operation very easy and smooth  feeding the board through the router table.

Seth