I am having an issue with the fence on the Kapex. My saw is only about a month old and hasnt seen much use. I am renovating a house we bought here in Norway. I am not a pro or a carpenter so your advice is appreciated as I'm way out of my area here.
I have read previous discussions on adjusting the fence. The fence is about .5 to 1mm out on the right side of the fence from nearest the blade to furthest.
In other words if I push a straight edge against the fence then I have a .5 to1 mm gap between the straight edge and the fence about half way down the right side starting closest to the blade moving right.
The entire fence being one piece I can tighten the left 2 bolts and then loosen the right 2 and push the fence backward until it bends into the proper position. I can then tighten it and it will hold for a day or 2 but then back to the same problem.
Am I being too picky considering its .5mm or should I take my saw back in for a fence replacement??? It makes it very difficult for me on particular cuts.
I have read previous discussions on adjusting the fence. The fence is about .5 to 1mm out on the right side of the fence from nearest the blade to furthest.
In other words if I push a straight edge against the fence then I have a .5 to1 mm gap between the straight edge and the fence about half way down the right side starting closest to the blade moving right.
The entire fence being one piece I can tighten the left 2 bolts and then loosen the right 2 and push the fence backward until it bends into the proper position. I can then tighten it and it will hold for a day or 2 but then back to the same problem.
Am I being too picky considering its .5mm or should I take my saw back in for a fence replacement??? It makes it very difficult for me on particular cuts.