This seems to be happeing more often to my Kapex, when the bevel is locked there is still movement. I'm in the habbit of alway checking to see that my bevel angle is where it needs to be but this is getting annoying since I'd like the bevel to stay where I set it. Is there an adjustment that will allow me to tighten the bevel lock? My Kapex spends most of the time in the shop and gets transported on site only when needed (3-4 times a month)
Kapex lose bevel lock
- Thread starter edson
- Start date
- Joined
- Jan 22, 2007
- Messages
- 8,426
Edson,
Welcome to the forum, I wish it was under better circumstances that you introduced yourself to us.
I would recommend that you contact the service department for assistance. I don't believe there's an adjustment that can be made, but I could be wrong.
It appears that you're located in Canada, I will mark your forum accounts accordingly. You can contact the Canadian service center at 613-363-0169 or the US service service at the number below in my signature.
Shane Holland
Festool USA
Welcome to the forum, I wish it was under better circumstances that you introduced yourself to us.
I would recommend that you contact the service department for assistance. I don't believe there's an adjustment that can be made, but I could be wrong.
It appears that you're located in Canada, I will mark your forum accounts accordingly. You can contact the Canadian service center at 613-363-0169 or the US service service at the number below in my signature.
Shane Holland
Festool USA
