KAPEX workstation

[Hicky]

Hi, just had a look at KJN site and the 45x45 has a 10mm slot and I believe 40x40 has a 10mm slot to
Not havin any clamps etc .
I haven't got a clue what size it should be
Thay make  profile with 6mm,8mm' 10mm. Slots ?

 

[wow]

Looks VERY nice. I would be PROUD to have my Kapex sitting on that...

 

[VW mick]

Looks really cool

I've not got a kapex yet .but doesn't it hit the corner when you turn it to 45%

 

[Davej]

Hi, just had a look at KJN site and the 45x45 has a 10mm slot and I believe 40x40 has a 10mm slot to
Not havin any clamps etc .
I haven't got a clue what size it should be
Thay make  profile with 6mm,8mm' 10mm. Slots ?

The clamps will fit in the 8mm slot with a little bit of filing off the back edge of the clamp

 

[Acrobat]

Awesome looking workbench/kapex station. A credit to you. I like the fact it on wheels too., Great job. [smile]

 

[mattfc]

Looks really cool

I've not got a kapex yet .but doesn't it hit the corner when you turn it to 45%

No it doesn't hit, the width of the lowered section that the KAPEX is bolted onto is wide enough, it's a little wider than the KAPEX base itself

 

[GarryMartin]

Looks really cool

I've not got a kapex yet .but doesn't it hit the corner when you turn it to 45%

No it doesn't hit, the width of the lowered section that the KAPEX is bolted onto is wide enough, it's a little wider than the KAPEX base itself

Excuse the crappy photo, but I had to grab one off the Internet so that you can see an example of why VW mick (and I) think the close sides would cause issues with turning the bed for angled cuts. Hope the question makes sense now.

[attachimg=1]

 

[VW mick]

Ah I see the kapex turns within its own width

Of course it does ,sorry don't know what made me think it wouldn't    [big grin]

 

[GarryMartin]

Ah I see the kapex turns within its own width

Of course it does ,sorry don't know what made me think it wouldn't    [big grin]

Errr.... not when you account for the handle it doesn't.

 

[BigBerti]

Looks very nice.