Kitchen underway

everything is off the shelf, no point making something that someone can make cheaper and better than yourself. They are a laquer finish door and the finish is very good high gloss
 
2011-12-07101029.jpg


tiny bit to finish after floor goes down
 
Sound!

Surprised the floor didnt go down before the work top returns went on the sides now you have to try and cut round them but then how do you leave a expansion gap

JMB
 
Well it was mentioned but i dint fit the tops and im not fitting the floor so it isnt my problem now
 
jmbfestool said:
Surprised the floor didnt go down before the work top returns went on the sides now you have to try and cut round them but then how do you leave a expansion gap

Looks good. Clean and simple.

Do you know what the final solution was in regards to what jmb mentions above??
 
Deansocial said:
yeah theres room for it at the other end

Its engineered so not to bad!        But I had a solid floor fail by just leaving expansion on side only.

I won't be doing that again!

Jmb
 
Heres another
Started this morning on this porcelanosa kitchen.
View this morning
IMG_20120806_082456.jpg

End of the day
IMG_20120806_173415.jpg

Nice touch on the sink units
IMG_20120806_173425.jpg

Metal legs
IMG_20120806_173443.jpg


Thing i didnt like was the dead size end panels so they have a gap as scribing to get them back might impact on appliances but i dont know because they aint there.
 
I hate end panels dead on size!  Who ever decided that was a good idea are a complete IDIOT! and need shooting really! they need their head kicking in!

any way!   In the past I have made a feature out of it by  sticking a 40mm or so piece of end panel to scribe to the wall and then stick another 40mm or what ever you want at the front but have it set back  then stick the dead on size panel on top looks quite nice!  BUT you do end up needing to get another end panel to cut up other ways to get around it but CAULK is not the option if its above 5mm  [big grin]

JMB
 
These are high gloss black panels so you cant really see the gap. Gonna tape up and silicone it up with black. Its the option the customer wanted
 
Back
Top