KV-SYS D8

[rinusripsus]

Is there a reason why the domino's used in combination with KV-SYS D8 are D8x36? I see in the instruction to cut 15mm and 28mm, so the default D8x40 should fit perfectly?
Also, I see all examples using the KV D8 on (outer) corners and KV-LR32 D8 on 'shelves'. Is there a reason not to use the KV D8 on 'shelves'?
Support strength is not an issue in my current project.

 

[squall_line]

Sedge explains in the Festool Live episode for the DF 500 connector set; they're designed so that you can use them on 18mm center panels with a thru-mortise; 28mm into the edge of the top/bottom plus 18mm/2 = 9mm distance through the center panel = 37mm.  The 8x36 allows you to use one on each side with a small gap in the middle.

Cued up to where he talks about it in the video (the whole thing is worth watching if you haven't already):
=1949s

 

[rinusripsus]

Thanks for the quick reply. I'll use the normal D8x40 for corner connections!
Watching the whole video right now.