So my daughter has just had her second birthday, and I wanted to make her a toy so have built this wlanut and cherry wood cooker sink unit. It was a bit of a last minute project so don't have and build pictures. I started off with rough sawn 26mm waney edge cherry and walnut, resawed and planed. Quite a few tools used, so to name some of the key ones
-Hammer N4400 Bandsaw
-CMS with the OF1400 & TS55, Festool Jigsaw in the CMS plate to make the hob plates
-Domino
-RO150FEQ
-Jet Pillar drill (for the cooker knobs)
I finished it using a wipe on tung based product *Finishing oil by Chesnut products)
And finally getting some use!
-Hammer N4400 Bandsaw
-CMS with the OF1400 & TS55, Festool Jigsaw in the CMS plate to make the hob plates
-Domino
-RO150FEQ
-Jet Pillar drill (for the cooker knobs)
I finished it using a wipe on tung based product *Finishing oil by Chesnut products)




And finally getting some use!
