Leigh jig and OF2200

HowardH

Member
Joined
Jan 23, 2007
Messages
1,580
Location
Albuquerque
Merry Christmas, Fellas!  Hope all your Festool dreams came true.  I was going to get started on a project for my son which included through dovetails.  I have a OF 2200 mounted in my CMS GE and I realized I have no way of mounting the Leigh RTJ 400 guide bushing into the table.  Am I missing something?  I have the accessory kit and looked through it looking for a template that would work but it doesn't seem to have one.Any ideas?  I'm probably just forgetting about something but at the moment it's not readily apparent. 
 
Yes, I have that but the opening is too large and the Leigh guide bushing falls right through it.  I suppose I can dust off my Of1400 and mount it instead.  I pretty sure it works in that router. 
 
I think you are right.  Way too much trouble for a very occasional use.  It only take a few minutes to swap out a 1400 with the 2200 so that would seem to be the way to go. 
 
I went out to my shop and looked.  The guidebushing fits perfectly into the template for the 1400.  Good thing I didn't sell it! 
 
Back
Top