LR 32 Edge Guide register pin diameter and length?

[Audios]

Hi!
Newbie alert! Both with the forum and the green slippery slope...

Can anyone tell me the diameter and length of the registering pin on the LR 32 Edge Guide (485758)? I'd like to register the guide against (1) the front edge of a cabinet and (2) in the groove that will be cut for the rear panel, so that the front and rear rows of holes will be evenly spaced without having to change the guide setting. It seems to me that the pin diameter determines the minimum groove width and the pin length determines the minimum depth, but I can't find the specs anywhere.

Thanks for any help!
Audios

 

[GoingMyWay]

I measure a diameter of ~5.95mm and a length of ~14.28mm.

[attachimg=1]

[attachimg=2]

Are these the specs you were looking for?

 

[Audios]

Yes! Thank you very much. It helps me decide if I'd get much use out of them.

The pin diameter means a minimum 1/4" rear panel thickness if the pin is to fit in the slot. Dang, that's kinda chunky for some lightweight cabinets I'd like to build for my wife's card-making hobby. I guess I could make a few replacement blocks with narrower pins.

Great pics! Thanks again!
Audios